U-blox has released NORA-W10 Wi-Fi - 4 and Bluetooth low Power 5.0 modules. The module is designed for harsh industrial applications. The device is a successor to the Nina-W10 module, adding key features including Wi-Fi 4 and Bluetooth LE 5.0, improved RF performance, built-in high-capacity flash memory and low power consumption. Single-band 2.4ghz Wi-Fi 4 (802.11b/ G/N) is launched for the low-end Wi-Fi segment that does not require the higher performance of the high-end Wi-Fi 5 and Wi-Fi 6 modules. The module measures 10.4mm x 14.3mm x 1.8mm,
UF3N170400B7S JFET is a high-performance Gen 3 SiC normally open JFET that provides engineers with an excellent solution for overcurrent protection circuits, DC/AC inverters, motor drivers, switching mode power supplies, power factor correction modules and induction heating applications.
Analog Devices Inc. has released a new combination of the next generation of 16-24 bit ultra-precision SAR ADCs. The new high-performance SAR ADC family features the company's patented Easy Drive technology and the generic Flex-SPI SPI, addressing system design challenges. And expand the selection of directly compatible supporting products.
Amritech announced an enhanced partnership with Bluetooth AB to provide a new unified test solution for 5G mobile OTA measurement. The solution consists of the MT8000A and MT8821C(now optional) as well as bluetooth RTS65. MT8000A is an all-in-one 5G test platform that provides RF parameter and protocol testing, functional and application testing, beam characteristics verification, and more. The RTS65 OTA reverberation test system optimizes the time required for OTA measurements to improve r&d productivity.
ROHM Semiconductor Europe has introduced new power semiconductor solutions for e-mobility and energy conversion applications. One of its new power innovations is its 4th generation of SiC MOSFETs. It attains up to 50% lower switching loss and 40% reduction of ON resistance with no sacrifice to short-circuit ruggedness. The latest generation provides a more flexible gate voltage range (15-18V) and supports turn-off with zero volt – allowing simple gate drive circuits with unipolar supply to be employed.
Microchip Technologies announced five new product families and more than 60 new standalone devices that combine ASIC-like capabilities and simple development experience to extend the capabilities of traditional MCUS so that they can be configured as smart peripheral chips. The challenge of crossing multiple voltage domains is a common situation in systems with chips that use different supply voltages
C&K expanded its PTS125 product line to 5 million drive cycles. The series is a 12 mm x 12 mm haptic switch used in a wide range of consumer products, instrumentation and computing devices. The series offers a variety of driving forces (130, 180, 250 and 350GF) and THT/SMT options, providing flexibility when looking for the right design version with a variety of heights (4.3,7.3,8.5 and 12mm) and further snap-fit actuators for a smaller, more robust final product. The full range of tactile switches offer IP40 dust seal, 50mA @ 12VDC and SPST-NO
Omni Pro Electronics has unveiled the new NAZR series surface mount high CV aluminium electrolytic capacitors released by NIC Component. The series is a recommended alternative to the traditional NACKA series (NRND) for applications including cellular network infrastructure, enterprise-class, power circuits, power control and load regulators.
ROHM has added seven new devices, the R60xxVNx family, which is optimized for power supply circuits for industrial equipment requiring high power. The new series uses the latest proprietary process, while two lower ON resistance models have been added to the R60xxYNx series standard low ON resistance 600V superjunction MOSFEts
Analog Devices, Inc., has released a three-axis MEMS accelerometer that delivers twice the power consumption and 30% more noise performance compared to its predecessor (ADXL362). When output data rate is 100Hz and the motion-triggered wake mode is 180nA, Only 0.88 µA is consumed. It also features a deep multimode output FIFO, a built-in micro-power temperature sensor, an internal ADC for synchronous conversion of additional analog inputs, single/dual tap detection and a state machine to prevent accidental triggering.
Lane Electronics now offers new FIBERFOX Extended Beam Fiber optic connectors from NEUTRIK. These connectors were developed to meet the requirements of the MILDTL-83526 specification and use IP68 to seal non-physical contact optical fiber terminals behind anti-reflective coated ball mirrors. The connector can be installed front and back. The connector eliminates the adapter and female and male half matching requirements. The system is available in dual and four-channel variants with configurations compatible with other mil-DTL-83526 specified systems.
According to KPMG's Global Semiconductor Industry Survey 2022, 56 percent of leaders believe the chip shortage will end by 2023, while 42 percent believe it will end before the end of 2022
Advantech has released SQFlash 840F and 920F series that comply with TCG-OPal standard. To meet various application requirements, the SSD series provides AES-256 encryption engine that complies with TCG-OPal standard to achieve advanced self-encryption. In addition, Firmware is assigned a digitally signed firmware code to prevent unauthorized changes further to the SSD root.
Analog Devices, Inc. offers a complete 10BASE-T1L Ethernet solution. The new ADIN2111 adds remote Ethernet connectivity for sensors, controllers and actuators, providing more efficient and sustainable building management insights. The device is designed to leverage existing single-twisted pair cable infrastructure in buildings, Data is Daisy chaining in lines and ring networks to reduce retrofit costs.
Nexperia has released its latest addition to a growing range of discrete devices that it offers in a lead-free DFN package with wettable flanks. The AEC-Q101 family of devices covers all of the company's product groups, and the lead-free DFN package is 90% smaller than the SOT23 package, which helps reduce the amount of board space needed to meet the growing number of electronic components used in the latest vehicles
VIAVI Solutions has introduced the ALT-9000 Universal Radio Altimeter (RADALT) flight-line test device. The device is a portable test device that uses optical fiber delay to enable it to work with all types of radio altimeters. The entire RADALT system can be tested, allowing operators to isolate problems to antennas, coaxial cables, LRU, or indicators, eliminating unnecessary replacement or replacement of system components. The complete, efficient, and user-friendly test process allows for more frequent flight system testing and reduces the cost of takeoff failures.
Microchip Technologies has announced its GridTime 3000 GNSS Time Server - a software-configurable solution for a system that generates precise time and frequency signals to synchronize analog and digital communication systems. The Precision Time server complies with IEC 61850-3, an environmental component of IEC 61850 that is the industry standard for defining substation communication protocols. The system includes a hardware-based encryption assurance module that uses RSA and AES encryption based on industry standards to prevent unauthorized malicious code configuration uploads.
Feiling Technology Co., LTD has launched a new battery management IC series, including TLE9012DQU and TLE9015DQU. The new battery management IC is a competitive system-level solution for battery module, battery to battery pack, and battery to vehicle battery topology. The device is suitable for a wide range of industrial, consumer and automotive applications such as MHEV, HEV, PHEV and BEV. TLE9015DQU is a battery monitoring transceiver IC used to connect several TLE9012DQU devices within the Daisy chain of lithium ion batteries.
